icecon

u/icecon


r/ebaysucks•

I purchased a pitcher describes as "beautiful and unique piece made of copper" that still had the label attached to the handle, the text of the label itself was not pictured in the listing.

Seller ships fast, it arrives, and I look inside and it seems there is some kind of dried laquer pooled on the bottom. I then check the label, "Stainless Steel Pitcher."

I understand copper prices are high and maybe I should have expected this but if it was at least copper plated, I probably would have kept it. I'm not drinking hot liquids from plastic though.

Doing a return... for this age old problem.

03

r/Lyme•

Timeline:

  1. Bit Mar 26, actually felt bite on upper left leg near groin, thought it was acne at first but shortly investigated further, removed nymph deer tick within ~3 hours of being in woods. Disinfected wound hole with alcohol immediately. Did not bleed.
  2. No EM rash presented thus far, aside from initial bite site inflammation.
  3. 8 Days later, odd left elbow pain (I hadn't worked out) into left wrist pain, tingling and shooting pains.
  4. Went to Urgent care on day 9, still with same symptoms, doc said I "did not qualify" for anything. Was past the 72 hour CDC rec'd one dose prophylactic (apparently I'm better off this way) and the doc was evidently convinced Rash=antibiotic cour
29

r/embedded•

So my main control MCU will be an RP2350, but the system will have a set of many small connected nodes, and each node needs a basic MCU.

I had a preference for RISC-V and was initially going to go with a CH32003 chip, but recently found out it has [two PFIC controller bugs] (https://x.com/NemecekPanda38/status/2007536163435823131), which seems like it would need a hacky workaround. After extensive research, I've landed on the 9 cent 24mHz M0+ PY32F002BW15S6TU. English datasheet looks good. I wouldn't need complex functionality out this, just low latency switch polling, RGB LED control, and a RS-485 transceiver link.

I know the STM32C0 is "default" pick for this sort of thing, but even at 3

58

r/ChainsawMilling•

Goal is to maybe get into hardwood milling as a side hobby/hustle, and also buck about 2 cords of firewood per year. I only have a plug-in electric saw at home, so need a gas chainsaw anyways even if I don't mill.

After extensive research, I've narrowed it down to these seemingly good value buys:

I belive these are all Zenoah clones:
"Purple saw" - $80 Temu Wemars 5218g $99 (amazon) - older chinesium model but seems to have diehard fans and reliability Semoxbit 20 in bar $120 (amazon) - new chinesium, unknown reliability but seems to have good cooling and seems sort of "pre-ported." Neotec 58 cc 18 & 20 in bars $119 (ebay) - great value with extra bar

Neotec 660 25 in bar $323 - popula

36