My ageing Botvac Connected "Marvin" has taken to complaining that I need to open "his" dustbin cover and press the ON/OFF switch down to "ON". It does this about 45-50 hours after finishing a run around the house. It regularly bleats about it and it's driving my wife nuts, she's threatening all sorts of homicide and vacuumicide, implying that would be a single violent act. But it is switched on, and it has a full battery, easily sufficient to cover 80 sq metres on turbo mode. If I can get it to start (after one or two attempts actually switching it off and then back on to reset it, with it away from the charger) it then runs fine and stops bleating for another couple of days.
I've collected together several useful pieces of information relating to GRBL v1.1f. It's not always easy to find them all in one place, so I made myself a document listing the gcodes GRBL recognises, the $$ parameters and their meanings, the immediate commands, the errors and alarms codes, the meanings of the OPT codes, etc. It's available at http://www.dunnington.info/public/CNC/ if anyone thinks that's useful.
Anybody tried Eryone or 3D Tomorrow or eSun wood fill filaments? Any other recommendations?
I've almost finished a roll of Sunlu woodfill PLA, pretty disappointing matt beige-coloured stuff which prints nicely but doesn't take wood stain any better than ordinary PLA and doesn't change colour at all over a range of 185C to 225C.
So I'm looking for something more realistic looking, for some small models. I see many people using Hatchbox, but it's expensive here, and I've seen Eryone Dark Wood which looks good on Amazon, 3D Tomorrow Wood PLa which is a UK brand, and eSun (and many others of course).