ondra

Is there a good way of adjusting E steps, flow, extrusion multiplier or something similar at runtime?

In an IPython notebook, I'd like to make a table with a column which contains a small plot of a time series.

Is there a not too convoluted way of doing this?

I don't mind pulling in additional libraries.

mov #P1OUT, R10 ; 2 cycles
mov.b #0, @R10 ; 4 cycles 

the write needs 4 cycles to execute.

Or 3 cycles for a PUSH with the stack pointer set to the address I want to access, but then another cycle is necessary to fix the stack pointer anyway. Also it's an ugly hack.

4 cycles per write seems like a lot. Is this accurate or am I overlooking something?