ragzilla

In about 2 weeks we should have our 375 gallon hot tub finally in place, and on the advice of this subreddit and TFP I went ahead and got the Taylor test kit and just tested my fill water last night, and learned some more things about the wonderful limestone aquifers our ground source water comes from.

7.6 pH | 350ppm TA | 475ppm CH (unsoftened)
310ppm TA | 50ppm CH (softened, skipped pH)

To deal with the CH, I'm planning to have a plumber run a new outside spigot off the hot water (continuous, gas) heater which is downstream of the softener, I have an external bypass on the softener so I can mix it appx 35/65 (forget the specific ratio, need to recalc it, using a hose gallon counter to

2 months out of warranty and the s9+ no longer sucks and instead throws an error 30. After tearing it down there's no physical damage (as has been seen in a few other cases where the impeller guard catastrophically fails), but putting a multimeter on the motor shows a lot lower resistance than I'd expect for a motor winding (and 2 that seem completely open). Spares site doesn't seem to have one available for order, but I'm hoping someone here might have an alternate place they go for roomba parts.

https://cdn.discordapp.com/attachments/698017988695162960/700071045989662820/ACNH_-_Matt_-_Koholint_2020-04-15_15-51-07.png

Bred according to Paleh's guide and cloned out to 4 pairs, used to bootstrap my Blue rose cloning.

Also got Gen1 Red Hybrids, and the Orange/White* pairs from Paleh's guide (for breeding more Gen2 Red Hybrids if you don't want to clone them).

-Edit-

1 pair sold, still have 3 pairs. As well as the other breeding stock mentioned downthread free to a good home.

Looking for a white air con (inside unit), to purchase or just catalog. Trading your choice of bells or NMT.