I have a S1 Pro and have printed well with it. I have now installed a Sonic Pad. Everything appears to be working correctly with the exception of setting Z offset. I was not able to set a negative z offset. So I releveled to bring the bed closer to what was considered a 0 offset. No matter what I seem to change the offset to it seems to reset constantly. It's proving to be ridiculously difficult to adjust a significant amount of offset as the print is starting. I can't seem to get the correct z offset to save and stay. Does anyone have any experience with this?
This seems like a long shot. I've been hunting for some hight temp refractory cement to line a forge. I'm coming up empty. Looking for satanite or kast-o-lite or equivalent. As you can expect shipping is expensive so im hoping to buy local.
So I've been vaping since the beginning of time. My daily driver has been a paranormal 250c with a zeus x. I always vape 3mg but usually salt based. So im not big on large throat hit. However I picked up a little smok nfix pod system a week ago. I've been vaping 20mg salt in that and its been fine. My question is that some vendors im seeing only have 12 or 25mg. What's your suggestion/input?
I've been diving down the rabbit hole of knife making recently. I've been looking at getting or building my own small starter forge. I've seen a few people recommend forges from Devil Forge. I've been looking at the DFPROF2 2 burner gas forge from them. I can buy it for $240cdn/180usd. I don't think I could build one much cheaper. What's everyone's thoughts on these?
None of my local B&M's sell Mango Milk E-juice by I Love the Milkman. If you haven't tried it, this stuff is fantastic.....but expensive. Anyone seen any good deals on it online or know of any close alternatives?
