sposter

u/sposter





r/MouseReview•

​

https://preview.redd.it/xp28a4bguql41.jpg?width=3072&format=pjpg&auto=webp&s=18d2e229e65a9b7b948a073855a43effad5d209b

One of the three pins will be much harder to desolder than the others. On my Logitech it was the cable-side one which thoughtfully had a square pad indicating it's the ground pin. On my Zowie it was the center pin with no indication. Because I'm not trying to preserve a micro-switch being removed the most convenient solution I have is to snip the housing to pieces so the pins can be yoinked out one at a time while holding the iron to it. There's two holes in the plastic that will conveniently crack apart when you snip them. [Afterwards the pads can

34

You've reached the end of this feed.