My Ender6 with the BLTouch is driving me insane. I have two issues that i can't resolve.
When i go into the leveling screen and the nozzles probes for the home position the nozzle stand quite a bit away from the bed. Then i use both z buttons on the left side to bring the bed up until the nozzle scratches a bit on a paper sheet. After that i double tab the home button on the left side to save the z value and the probe starts probing again for the home position. When the nozzle reaches the home position, i have noticed that the gap between the nozzle and the print bed is not what i have adjusted before double tabbing the home button. The nozzle is then a bit higher then before and don't tou

