I was almost 24 hours into a 37 hour print when I realized that the arm in the back was hilariously under supported. After a few hours of babysitting, and trying to keep it in one piece, the tip of the hot end grabbed some of the messy infill on the arm and knocked it into the tree support, breaking the tree support. Being too deep into the print(as well as stubborn and impatient,) and having already wasted that much filament on this and a few other failed attempts, I was scrambling to figure out a way to try and salvage the rest of the print, and... super glue and duct tape solve everything, right? 

  
Luckily, I think the mess under the head is just the ends of the supports, and if there 

thatbilliter

When you are too stubborn for you own good

Project Pair

It's Friday. You know what that means.