trovanhawk

u/trovanhawk


r/ArtilleryGenius•

Is there an alternative to the cheap plastic Artillery ABL sensor?

My printer has broken a second pin because of a simple failed print. A failed print should not cause $40+ of damage to my printer every time it happens.

I am not happy with Artillery right now.

14

r/ArtilleryGenius•

I was doing a pretty basic PETG print. I watched the first few layers as I do and everything seemed fine. I left the room and only checked on it again a few hours later. The printhead was down against the print bed, still printing, but it had made a big glob of filament that was all over the hot end. The print had worked fine for about 10mm height, then for some reason it dropped to the bed and knocked the unfished print off the plate.

The silicone cover over the hot end filled with filament that has since hardened and I'm not sure I can ever get it off.

I have two questions:

Why/how did this happen and how do I prevent it from happening again?

Where is the best place or best brand o

31

r/Fireteams•

I have not been able to d a raid yet. My clan never has enough on. Can someone invite me and maybe show me the ropes? I'm a 958 power Warlock, so it wouldn't be a pure carry.

​

This is for D2, by the way.

35

r/HadesStar•

Hi. I know barrier stops movement of enemies and missiles. But does it stop an enemy from using and EMP or any other modules while within the radius?

72

You've reached the end of this feed.