tyreck

I just picked up a new Pi Zero 2 W and loaded the newest image on it (trixie lite 64bit) and i cannot get this thing to connect to my 2.4ghz network...

It looks like i'm having a similar problem to this person: https://forums.raspberrypi.com/viewtopic.php?t=362819

(I also have an ASUS router as they mentioned)

and this person: https://www.reddit.com/r/raspberry_pi/comments/1caczgq/pi_2_zero_w_wifi_issues/

How have i confirmed it isn't something stupid?:

1. If i take the SD card out of the zero, and throw it into a 3B it starts right up a

First to clear it up, i have no interest in mixing and matching them, and know why its not good.

I ordered some TrueRC Singularity LHCP antennas for a walksnail setup, and i received ones with a red cap, and an unmarked package (normally it would have a sticker on the baggy identifying them).

I'm pretty sure the colors are TrueRCs way of identifying them isn't it? Red = RHCP & Grey = LHCP?

Its fine if they are RHCP, i can use them for something else, but i wanted to confirm this, so i threw them on a tinywhoop and flew around the house, the breakup seems...... just slightly worse between the new one, and a confirmed RHCP.

I've never tried to mix them, so i have no idea how bad the sig

I'm looking for some insight, either in how to confirm, or just your hunch on it.

Yesterday i installed a new set of motors on my (2021) Meteor65, going from 0802 to 0702 and shedding 2 grams of weight and upping the KV.

Despite being a 2021 model, i was out of it for a while and didn't unbox and use it until about a month ago for the first time. It had flown fine up until this point and had not lived a hard life.

I was doing some test flights in the house, and practicing catching it after a flip. I crashed, but not particularly hard or anything, and onto carpet, though in hindsight, i am not sure the crash was my fault and it might have been the start because i hit the ceiling, but had

I just finished building a CoreOne kit and am at the stage of tightening the belts following the instructions

First, the app doesn't seem to work at all on my phone, or its really really delayed to the point i can't tell when it picked up a noise, and web site is more responsive to show changes but there is no feedback as to it actually hearing something and the numbers just jump all over the place

I downloaded the Carbon Drive app, and it also jumps all over the place, varying between 20hz and 120hz between strumps. This was easier to follow because it shows the sound wave indicator when it hears something so you can correlate the noise to the value and know its not background noise