Highlight Of my weekend

Fan Art
Highlight Of my weekend

Posted Jul 19, 2023, 2:13 AM UTC

17
dpidcoeOP•

This was me and some friends showing our coilgun to mehdi at opensauce. Some quick stats on it:

  • ~10 joules of muzzle energy (40 gram projectile travelling ~22 m/s)

  • Projectiles are 12mmx50mm machining dowel pins from mcmaster

  • The coils draw about 600 amps from a pair of 6S lipo batteries in series (so 12S total) during a shot

  • The efficiency is terrible, but it doesn't matter since we have so much excess energy to play with

  • Can fire as fast as you can load projectiles

  • Closed loop coil timings using IR LEDs and sensors + a teensy 3.2 microcontroller running on a 10khz loop

1
melectorMehdi•

Nice project! I should do it EVEN STRONGER!!!

1
dpidcoeOP•

I should do it EVEN STRONGER!!!

YESSSS!!

For next year we're already planning on at least 2x the stages and doubling the kinetic energy. Make a bigger one and exhibit it next to us >:3

1

Why didn’t you use a capacitor bank? That way you can use many kilo amps.

1
dpidcoeOP•

Why didn’t you use a capacitor bank? That way you can use many kilo amps.

It was a deliberate design decision. The thing with coilguns is that changing one thing changes everything else, which means that a capacitor based coilgun is a completely different beast:

  • To get energy from capacitors, you really need to go to a higher voltage (e.g. >400V)

  • Once you're at a higher voltage, the coils can use a thinner wire and more turns because enough voltage exists to overcome the coil resistance and inductance

  • A coil activated by a capacitor starts losing its field basically the instant it reaches maximum strength, which means that the timing for turning on the coils is as critical as the timing for turning off the coils

The end result is just a completely different gun that might be better off as a single stage with a bigass coil giving 100% of the acceleration. Compare to powering it directly from high current batteries:

  • The voltage stays at ~50v, which is right on the OSHA limit for exposed wiring and bus bars (i.e. you're probably not gonna die from inadvertently touching something, which is a real risk you take with a 500V+ coilgun that I don't think a lot of builders take seriously enough).

  • The switching algorithm is dead simple. For example, a really naive implementation could turn on every coil all at the same time at the start of the shot (yes, real world battery constraints make this suboptimal but bear with me), and all we need to worry about is switching them off at the right time. A smarter implementation just turns on the coils as needed, but because of the amount of stored power in the batteries we can turn them on quite a bit ahead of time to ensure they're at maximum field strength before the projectile gets there.

1
CGLab•

nothing is exploding. I can't see any highlight item

1
YTshashmeera•

Nice build

1