Banana Pi R3 + OpenWRT, better WiFi speed overall, capped on Windows upload only.
Hello everyone!
I have recently installed OpenWRT (23.05.3) on my Banana Pi R3.
I have a 1Gbps upstream connected to the Router RJ45 WAN port, and I have enabled both 2,4 GHz and 5 GHz WiFi, on different access points.
I set the 5 GHz WiFi as follows:
- Channel 56: Much more free than 36 according to the scan, I tried using higher channels such as 100 which are empty on the scans, but my devices failed to find the WiFi signal.
- Width 160 MHz: I have multiple 160 MHz capable cards and I need the most out of WiFi
- Mode AX (it was the default)
- Transit power 20 dBm (also the default)
- I did set the country code to my country
- Left everything else on default
- Coverage Cell Density: Disabled
- Distance Optimization: Auto
- Fragmentation Threshold: off
- RTS/CTS Threshold: off
- Force 40 MHz mode: obviously off
- Beacon Interval: 100
Here's the problem, on my Android device, I get crazy high speeds, on speedtest that goes go up to the Internet, 888 mbps down / 791 mbps up, which is good.
On my Windows 11 device, which does support WiFi 6, is connected to the same Access Point and runs an Intel WiFi 6 AX201 160MHz wireless card, I get up to 800 mbps up and....... 5 mbps down.
This issue is exclusive to this Windows device so far, I tried reinstalling the Intel drivers instead of using the pre installed ones, no luck.
On another Windows 10 laptop the issue is reverted I get 3mbps down and 300 mbps up (the latter probably capped by the laptop WiFi card).
On OpenWRT I have enabled software flow offload and hardware flow offload, I tried disabling them too which seemed to produce about the same outcome, maybe slightly slower but it might be margin of error.
Unfortunately as much as I'd like to just use an ethernet cable, I can't. And I can't figure out what's going on here. Did anybody have any similar issue?
Very happy to provide further info if requested!
Posted May 18, 2024, 9:24 AM UTC