2C-B Nasal Spray Discussion

Most people know that snorting 2C-B is quicker and more efficient. But it just burns way too much. Nasal spray is apparently the solution to this.

I have made my first nasal saline with a concentration of 15mg/mL (1.5mg/spray). Most people report using either 10mg/mL, or over 20mg/mL. People complain of burning with higher concentrations. On the other hand, 1mg/spray seems too low, so I chose a middle ground. I will report back the results.

For this test batch, 75mg 2C-B HBr was placed into a shot glass. 5mL of nasal saline solution was measured with an oral syringe, then put into the shot glass. The 2C-B did not immediately dissolve. I repeated sucked up the solution with the syringe to agitate the solution. Most of the 2C-B dissolved quickly, Larger clumps of the powder took longer to dissolve. No more than a couple minutes. I'm left with a slightly cloudy solution. This will be run through a syringe filter to get rid of any undissolved impurities.

I highly recommend not attempting to DIY saline solution. Bacteria can still grow in saline, and there are reports of people getting sick from using old saline preparations. Pre-made nasal saline comes with preservatives to prevent microbe growth, and it's cheap and readily available. DIY preparations should be not be kept for long, unless frozen or refrigerated.

I'd love to hear your experiences with nasal spray.