Best approach to drive 9 steppers on one machine?
I probably won't go this far, but my WIP Trident toolchanger currently has a theoretical maximum of 9 frame-mounted steppers:
3x Z motors, 4x XY motors in AWD config, 2x liftbar motors for a mobile tool rack.
As I understand my options are:
-
Run the machine from 2x MCU boards (eg Manta M8P + M4P), with the M4P running the toolbar motors.
-
Just go 2WD as it's a toolchanger head and will likely be less rigid than is required for AWD. I'm considering this but I'd like the ability to change out the toolhead in future for a standard one and run it as a speed machine.
-
Put 2x EBB boards in the electronics bay and run the liftbar motors from them. Is this feasible? I'm assuming that the drivers on EBB boards won't quite have the grunt to run a regular 48mm NEMA17 at the same rate as stepsticks, but I could be wrong.
Couldn't find much about this kind of approach in docs or anywhere else, so asking here.
Posted Dec 27, 2025, 11:03 PM UTC