Magazines for the 6.8 SPC
INTRO:
Here is a review of the various 6.8SPC magazines that are currently available. This is based on the newer versions and not the old versions.
1. Barrett:
Positives:
-
- 30 round magazines that load smoothly. Only company that makes 30 rounders at the moment.
-
- Metal anti-tilt followers.
Negatives:
-
- Reliability is hit or miss.
-
- Expensive. ($40-50).
-
- Have to load the bullets short (approximately 2.255").
-
- Very long. 1" longer than PRI and C-Products 25 magazines.
2. C-Products: (2008 and newer).
Positives:
-
- Cheap. ($12).
-
- New 25 rounders are very reliable.
-
- 5, 10, 17, and 25 round magazines available.
-
- See #1.
Negatives:
-
- Can't load the bullets out as long as the PRI. (approximately 2.285").
-
- 17 Round Straight mags are not that reliable.
3. NEW PRI (Waffle Pattern):
Positives:
-
- Can load them out to 2.305"
-
- 5, 10, 15, and 25 round magazines available.
-
- Fit better in the magazine well.
Negatives:
-
- Reliability is hit or miss.
-
- Expensive. ($30-40).
4. OLDER PRI:
Positives:
-
- Reliable.
-
- Can load them out to 2.305"
-
- 5, 10, 15, and 25 round magazines available.
Negatives:
-
- Expensive. ($30-40).
-
- Issues with the followers being too short (Not actually PRI's fault as the followers are made by Magpul.).
-
- Fit very tight in the magazine well.
5. ASC:
Positives:
- Allow longer oal's than even PRI (better for reloads)
- Well Priced
Negatives:
- A few people report reliability and the occasional finish issue, but its rare
CONCLUSION: For most uses, the C-Products 25 Round Magazines are the best bang for the buck. The only negative about the C-Products Magazines is the springs are a little weak. I highly recommend replacing them with the ISMI or Superior Shooting 556 30 round magazine springs, which will last forever. For Precision Shooting, the PRI Magazines are a better choice because they allow a COAL of 2.305".
Be Sure to check out the rest of the guide parts:
Part 1 - Remington 6.8 SPC Guide
Part 3 - 6.8 SPC Ballistics and Bullet Info
Part 4 - Reloading for the 6.8 SPC
Posted Mar 5, 2014, 6:30 PM UTC · edited