r/RBA•
Ralt

Link RDA and Contact Coils

Hey guys, just looking for some advice. I can't seem to get contact coils to stay tight when I clamp the connection screws down. I've built a couple in a row now and I lose the form. If anyone has any tips that would be great. I tend to run into the same issues on any atomizers that don't have post holes. On my Omega clone I just gave up and used the holes, but the Link has no such option. Thanks for any tips.

Posted Apr 27, 2014, 11:47 PM UTC

520
MildlyMildA stillare•

Put them in and get them red hot and squeeze them to get them tight again, usually in new attys I can't get the coils in without fucking them up for the first dozen or two builds.

2
RaltOPiPV2/ZNA + Fogger/CLTv2•

I do that, can't get them snug again. Having the leads anchored creates enough force to pull them right back apart.

1
allo_87•

Then you need slightly longer leads. I have this issue once in a while and now leave an extra ~1/8 inch on each end until it's installed, just in case I need to adjust it. After it's in and good I'll clip the extra off and we're good to go

3
MildlyMildA stillare•

Show me a pic, as the other guy said, it sounds like you arn't giving yourself long enough legs to twist em a bit.

1
RaltOPiPV2/ZNA + Fogger/CLTv2•

I've got legs for days :, every coil was somewhat like this today.

http://imgur.com/CkH0sp4

I put it where I want, lead the legs around the screws, and screw them down. It's the act of screwing the screws down that pulls on the coil a tad bit.

1
aquadementia•

Have you tried leaving the coils on whatever it is you use to wrap around as you capture the leads?

2
Boardsurfer•

Twisted wire? I've never been able to keep twisted wire tight.

1
rammsdell•

How do you have the coil mounted in the RDA? I put mine in horizontally. That seemed to work pretty well.

1
RaltOPiPV2/ZNA + Fogger/CLTv2•

I'm doing the vertical necktie with cotton.

1
rammsdell•

I didn't have good luck with the vertical necktie builds. I had the same issue you were having.

1
RaltOPiPV2/ZNA + Fogger/CLTv2•

Good to know, on Lance's video he doesn't do contact, maybe there is a reason. I mean, besides that it's hard as fuck to do so on ekowool/silica.

1
StonyB•

Contacts and ekowool are rough. I did a dual cotton vertical necktie before going back to ekowool. I found for vertical micros, leave the coil on the bit/screw driver you wrapped on. Anchor the negative. Position the coil where you want it and put the wire under the positive screw. Leave just a little slack in it. As you tighten the screw, it will pull the coil into towards the center post. Long legs on micros usually don't get hot spots, so leave yourself some working room. I wicked with yarn.

r/steammonkey has a few build pics and tutorials.

1