r/Cartalk•
needanew

'07 Chevy Express 1500 Blower relay/motor

Blower was working only at max, found burnt connection on the blower control relay assembly. Replaced with new from the parts store. New relay/ control module smoked a little on initial power up, and no fan at all. Checked for power out--none. There is power to the relay, and all of the control wires have power when expected (as selected at the dash.) Old blower control showed 12VDC on red wire to fan. Replaced fan. Still no work. Found black wire to fan also carrying 12VDC when fan should be on. Ground wire from dash measures 1 Ohm to ground. Fan wires are both open to ground. Whats next? Did I wreck the new control relay with a bad fan? Ground Gremlins somewhere?

So I exchanged the blower controller, as soon as I plugged it in it got really hot and smoked. I'm not sure where to go now. As near as I can tell it's getting correct voltages from the dash.

Posted Oct 18, 2016, 11:55 PM UTC · edited

94
mtackett90•

Did you change relay or resistor? You'll have a step down resistor that changed the voltage out to the blower motor. Likely over heated due to age and cracked/ burnt out. Usually under the glove box or near the blower motor.

1
needanewOP•

All one piece on these.

1
ftpcolonslashslash•

If you're getting 12v across the leads, it might just be a bad blower motor. When they overheat, the insulation on the windings can melt off and cause a short, which can burn out the relay, though in that case I would expect the fuse to go first.

Does the blower motor rotor turn freely?

2
needanewOP•

It did. And it was new. All the fuses were good too.

1