2004 Chevrolet Suburban 180k miles - AC blows hot; always high pressure on low side

  1. Checked all fuses and relays (labeled HVAC or AC) - none faulty; originally thought the clutch wasn't engaging
  2. Low fill side on my cheap pressure dial is reading around 140 psi, does not lower when compressor engages
  3. Compressor and clutch appear to be turning; there appears to be grease coming out of the end of the clutch which was radially sprayed about the engine compartment
  4. Jumped the Low Pressure switch with a paper clip, no change
  5. Low and High sides are the same temperature to the touch
  6. Was working on the 4 mile journey to pickup my travel trailer, stopped working on the 4 miles back home. It wasn't working awesome, but it did blow cold air.

I do have the Automatic Temperature selecting HVAC ECAS whatever-its-called; both Front (Left and Right) and Rear AC is blowing hot, all failed at the same time.

Previous owner had AC refilled about every 15-20k miles on a nearly yearly basis the last 3-5 years; I just replaced the Blower Motor Resistor a few weeks before this happened.

Posted Jun 16, 2017, 1:37 PM UTC

04
I8ASaleen•

You might have a blockage at your orifice tube, likely as a result of compressor failure. Bad news is the whole system may need to be changed if that's the case since metal shavings may exist throughout. Cheap check would be to vacuum down the system, remove the orifice tube and drier to check for shavings, and if nothing vacuum and recharge.

2
peetzapie•

It would be nice to know what the pressure is on both sides. If the temp is the same then the pressures may be the same. That usually means the compressor isn't working. It can spin and still be bad, pistons and reed valves go bad.

That recharging has me thinking they may not have added oil too since some comes out when it leaks. Also when there's no pressure some moisture can get in which will cause issues. Don't know how empty it got. Like saleen said check for metal on the orifice tube. If it's there replace the compressor, accumulator, orifice, condenser, rear expansion valve and flush out the rest.

I'm not suspecting a temp blend door motor in the dash and rear unit because they won't all go at once and both pipes are the same temp.

2
wolfmannOP•

Thanks, I think you two just confirmed I'm taking it to a shop (I don't have a full weekend to dedicate to it before I need it back and it's a bit above my skill level & I don't have all the tools)

1
peetzapie•

Good move, that A/C stuff is really a bit complicated and best to have a shop look at it.

1