As a new turner, one of the first challenges that jumped out at me was trying to turn a perfect sphere.
Posted Oct 28, 2017, 12:58 AM UTC
Posted Oct 28, 2017, 12:58 AM UTC
Frank Howarth has done a vid or 2 on sphere turning. Give him a check.
One of the most poignant pieces of advice I heard was at SWAT two years ago. Even if you're a little off perfect, it's okay; as long as it looks spherical. Remember that wood moves, and even a perfect sphere won't be perfect six months down the road. Generally it will be close enough.
That said, the aforementioned pvc chuck system is good, and there are sphere jigs if this is something you want to batch out. Carl Jacobson has a few videos on using sphere cutting jigs (and I think one or two on cutting without a jig, but don't quote me)
https://www.rubberchucky.com/store/p23/_Sphere_Chucky__Set_-_Small_or_Large.html
This is a rubberized chuck that holds really well. Comes in different sizes, depending on the circumference of the sphere.
I'd love to try this. What tools/chucks do you use?
I've been making palm sized wood exercise balls for years, need any tips?
Open to any and all suggestions. Currently my process is to rough it out and shape most of the sphere and then part the tenons holding it in place. Then I rotate the sphere 90 degrees and hold it between two crudely improvised jam chucks to clean up the rest of it.
Right. You can start with any similar sides block of wood. First you make two plastic chucks from the mating ends of PVC pipe, two ends that have a thread on one side and smooth on the other. The smooth side goes against your block, the thread side you create ways to center on your tail stock and head stock, simply as turning wood to fit inside then epoxy the wood into threads. These new plastic chucks last forever. Now just compress the wood block between them, turn the exposed area, loosen, turn, and do another area. You do this about 3 times until it's round.
Never tried this, wandered into this sub, but I’d listen to some tips on this. Looks really cool