As you can see by the dye and the already applied JB Weld, that plastic 90 for the heater core is leaking. It's not a terrible leak but it's enough to be annoying. I plan on replacing that plastic 90 with a metal one soon. Until then, is there any reason I can't just bypass that thing altogether?
ExquisiteCheese
u/ExquisiteCheese
###Build Help/Ready:
Have you read the sidebar and rules? (Please do)
Yes
What is your intended use for this build? The more details the better.
Every day rig. Play God of War and Cyberpunk
If gaming, what kind of performance are you looking for? (Screen resolution, framerate, game settings)
It'll be on my 65" tv so high I guess?
What is your budget (ballpark is okay)?
About $1500
In what country are you purchasing your parts?
USA
**Post a draft of your potential build here (specific parts please). Consider formatting your parts list. Don't ask to be spoonfed a build (
With the kids doing school from home we need something better than a laptop. I've already got an rx560 laying around from a previous build. Any tips or recommendations would be greatly appreciated.
| Type | Item | Price |
|---|---|---|
| CPU | Intel Core i3-10100 3.6 GHz Quad-Core Processor | $129.99 @ B&H |
| Motherboard | ASRock B460 Pro4 ATX LGA1200 Motherboard | $89.99 @ Amazon |
| Memory | [Kingston ValueRAM 8 GB (1 x 8 GB) |
Seems like the welded in nut or the threads in the unibody (whichever) has failed on one of my sway bar mounts. Now I looked this up before starting and kept reading all I'd need to do is remove the bumper and I'd have access. Well, that's not the case. It seems the steering box has a block in there for support. So I need some ideas.
https://i.imgur.com/B6X1L1a.jpg
At low speeds it feels like my rear tires are deformed causing a lope or bounce feeling. At higher speeds there's a pretty good vibration. But once I'm off the throttle there's no irregularities at all. I've had drive line noise off throttle since I bought the Jeep. Have assumed it was either because of the lift or the transfer case chain is bad. But since the new stuff today popped up I don't hear the noise.
I'm gonna pull the front drive shaft tomorrow and test. If that's not the problem I'll change the rear U joint after that.
Is there anything else obvious I may be missing or should give a once over?
Just my journey with my second xj. One thing I didn't mention in there is that the motor was swapped from an 01 to a 98. So she's got a few quirks inside the engine bay and under the dash. Weird wiring and mounts. I'll get that figured out later. Oh, I'm also gonna paint it at some point. Blue or yellow. Can't decide.
I bought a jeep last week with a 98 motor sitting in an 01 body. Manifold is cracked so I ordered a 98 header. While I was under it today checking for any other damages I noticed that the 02 sensors weren't hooked up. After a quick googlin I learned that the 00-01s have 4 sensors while the 99 and early have 2.
Question is, how do I make the sensors work? Do I need to tap the new header for the sensors up there or just say to hell with it and not run any?



