Help! Printer stops extruding mid print - Now can't get any filament in or out!

Discussion

Hello!

I was initially having an issue with my last 2 prints where the printer would stop extruding mid print.

I have a Monoprice Select v2, and went to remove the filament; so first went to "Preheat PLA"; then after it was up to temp, I pulled back the tab that locks the filament in, and tried to pull the filament out. But it wasn't budging, and I can't push it in/force some to extrude. It won't budge in or out.

The display says it is at 215, and it feels hot (as I quickly touch it).

Any thoughts on what is wrong?

Thanks for your time! Nick

Posted Apr 26, 2018, 5:34 PM UTC

17
RhynocerousTAZ 6, Prusa MK3•

You probably have some PLA stuck in your heatbreak, it's not supposed to get hot so preheating wont free it. You can try forcing some through at a higher temperature but I would look into instructions to clear the heatbreak. I have not used a Maker Select v2.

Also double check to make sure your heat break fan is working properly.

2
albrnickOP•

Thanks! = )

1
albrnickOP•

Thanks! :)

1
AetherdyneMonoprice Maker Select v2•

Follow these steps for clearing a clog. That site also has a lot more info useful for owners of Wanhao Duplicator I3s (the Maker Select is a rebranded DI3).

2
albrnickOP•

Oh perfect! I'll definitely do! Thanks! :)

2
joochung•

Rhinoceros is probably right. Heat creep cause filament to melt in the cold end / heat break. You can try heating it up hotter and see if it will budge. If it doesn’t, then disassemble the hotend. Remove the nozzle and heat break. Put it on a tray and put it in the oven to melt the plastic out. I use a small kitchen torch instead of the oven.

2
albrnickOP•

Thanks!

1