Under extrusion issue i3 v2
Hey all looking for any advice on how to fix this issue.
Running a Monoprice i3 v2 with MicroSwiss hotend.
Below is a picture of the under extrusion problem I'm facing...
Recently had a bunch of issues with my printer that forced me to replace my thermistor, hotend heater, and I also switched to PEI vs builttak. Now that everything is running again my old settings aren't really working for PLA.
It seems very strange that the skirt and first part of the prints seem to print perfect but then the it seems to trail off. Printer comes up to temperature no problem, I've tried back on painters tape/glue like I used to use, tried a few different pla's (all kept in bags) but not sure where to go next. Printing with .3 layer height, 60c bed, 210c extruder.
Posted Apr 20, 2019, 3:39 AM UTC
Clogged nozzle. Or maybe old filament that's gone bad. Or you have something wrong with your hotend heating circuit causing it to cool after printing for a short while. Good luck!