Repeater antenna polarization and rx desense
I'm currently trying to design a small, lightweight, and relatively low power (8-25W) repeater to integrate into an RC aircraft to get local coverage in hilly and possibly forested areas.
I've got a fair idea of how I'm going to set up the electronics and control side but what it boils down to is the rx and tx antennas are going to be in very close proximity and from what I understand so far it'll cause quite a bit of desense on the rx side if I just use the bare radios. I hear that setting it up as a crossband repeater might help but I'd like to keep it to 70cm if possible. Cavity filters seem a bit too heavy and large in addition to being rather expensive.
My question is that I was wondering if I could use circularly polarized antennas for the rx and tx sides with one being left hand polarized and the other being right hand polarized to prevent the receiver from picking up the what the transmitter is outputting altogether.
From what I've read they should almost completely reject the signals generated by each other (given that the antennas are well made) but should be able to receive and transmit to "normal" linearly polarized antennas with 3db of loss. It's only intended for use with HTs so I don't expect anyone to try to connect with a helical or any other circularly polarized antenna and not be able to hear or talk to the repeater.
I'm open to any additional related advice or alternative suggestions as well. Please feel free to correct anything I may have misunderstood as I'm still a new Ham myself. Thanks for your input!
Posted Apr 25, 2019, 11:38 PM UTC