Prusament troubles
After hearing about how great prusament is and waiting months for it to pop back on Amazon, I finally got some last week. However, it has been an utter pain in the ass to print with. I used to get really good bows on benchy with Esun PLA+ and Hatchbox PLA, but now, if the print even finishes without jamming, I get really bad bows. I've tried every 5 degree temp range between 185 and 220 and have not had a benchy come out nearly as good as Esun PLA+. I read that prusament has a bigger issue with heat creep, so I doubled my printing speed @ 220 and started to get a nicer result, but the print jammed when it got to the pillars. I have a lot of faith in, and a huge amount of respect for, Prusa as a company, but this filament is driving me nuts.
Has anyone had similar issues using Prusament and overcome them? I feel like my last resort is to diddle with my retraction settings, but I'm out of ideas after that...
E:I'm using PrusaSlicer as well.
E2: lowering retraction to .4mm did not help the jams.
E3: Simplify3D fixed the bow/overhang. Still jammed though...
Posted May 22, 2019, 10:49 PM UTC · edited
I've used prusament, specifically doing filament comparisons with it and others, and it was one of the best printing filaments I tried.
The issue you are having looks like not having enough cooling on the part. Based on your tag I see you have a printrbot. I also have one and prior to doing a blower fan upgrade basically all of my benchies looked like yours so that might be something to look into if you don't have a fan upgrade already.
I have a blower fan.
Hmm. Might have just been a bad spool?
I guess that's possible, but I'm not sure what they could've goofed to ruin spools. The diameter's fine on it and I don't think someone just threw a bunch of bubble gum into the hopper. Also that'd be concerning because I have 3 more rolls that'd likely be tainted if they're from the same run.
Maybe try to get in touch with their support? Sorry I couldn't help more.