Using KZ ZSN Pro IEM's on a Dell laptop
This is my first "high-end" audio purchase and an upgrade from the Samsung earbuds that came with my phone. Since these IEM's are quite sensitive, I have to set my volume to 4/100 and set the digital volume on my music player to 30%. The previous cheap earphones were fine with the volume set to 16/100.
I hear a constant slight hum from the 3.5mm audio port when playing sound. The hum stops if my laptop is not playing any sound. Guessing the noise isolation on the laptop motherboard isn't that great.
Is there a software tool I can install to lower the power to the headphone jack or reduce the noise? I considered getting a DAC, but can't afford fancy tools like a FiiO. Is there an option closer to $20?
Posted Jun 1, 2019, 10:33 PM UTC
iFi Ear Buddy Audio Attenuator Cable for Headphones and IEMs Compatible with 3.5mm Headphone Jack - Travel Kit Includes Accessories https://www.amazon.com/dp/B075PVVHF5/ref=cm_sw_r_cp_apa_i_I7W8CbN9QCY76 I've seen this recommended for sensitive units, not sure if it will work for you or not.
I did a lot of reading and it appears the iFi Ear Buddy is 15 ohm voltage divider.
https://www.audiosciencereview.com/forum/index.php?threads/review-and-measurements-of-ifi-ear-buddy-and-iematch.4707/
https://diyaudioheaven.wordpress.com/headphones/headphone-attenuation-adapter/
https://www.shure.com/en-US/support/find-an-answer/understanding-earphone-headphone-specifications
The ZSN Pro IEM's have 24 ohm impedance (quite low) and a high power sensitivity of 112 dBSPL/mW (specs on the box). With that we can calculate the voltage sensitivity = 112 + 20log(sqrt(1000/24)) = 149.3. To compare with a typical IEM, the Shure 535's power sensitivity is 119 dBSPL/mW and 36 ohm impedance i.e. 119 + 20log(sqrt(1000/36)) = 152.24 which is about the same.
Funnily enough, 20 years ago I would've been able to pop into a neighborhood radioshack and build this with parts that cost cents and in less time than it took me to type this post. And then it hit me. All I need is a voltage divider... what I need is a cheap stereo extension cable with a plain old potentiometer volume control knob 😁😂😂.
The EarBuddy attenuates by 16 dB. Plugging your ZSN Pro into it, this brings the effective (total) efficiency down to 96 dB/mW. Which is still fairly sensitive, but not dangerously so with your laptop's built-in audio output.
Edit: by the numbers, since it reduces voltage by a factor of 5, it's probably more like -13.9794 dB
Thanks for the info, I had seen this in discussion but didn't need it and didn't know how it worked. I miss Radio Shack too!
I'll look into it. Comes to $44 CDN with shipping, import fees and taxes. I'll see if a local supplier here in Canada has it for lower.