I developed a new low speed bounce/high speed vibration only under power

At low speeds it feels like my rear tires are deformed causing a lope or bounce feeling. At higher speeds there's a pretty good vibration. But once I'm off the throttle there's no irregularities at all. I've had drive line noise off throttle since I bought the Jeep. Have assumed it was either because of the lift or the transfer case chain is bad. But since the new stuff today popped up I don't hear the noise.

I'm gonna pull the front drive shaft tomorrow and test. If that's not the problem I'll change the rear U joint after that.

Is there anything else obvious I may be missing or should give a once over?

Posted Jul 31, 2019, 7:13 AM UTC

212

Probably a tire issue. Check for any bubbles or uneven tread.

2
ExquisiteCheeseOP•

I've had the happen on another car before, it was felt as any speed no matter throttle input.

But I did check anyway. Don't see anything.

1
cofferson'01 Limited 175k and Rising•

Put a crowbar between the cross member and the transfer case and lift the tcase. Does it lift and separate from the cross member? When that mount goes bad, it'll bang around and stop once you release throttle. That's one option.

2
ExquisiteCheeseOP•

It doesn't separate but I did get some lift out of it. My passenger side motor mount has some space between the bushing and metal though. Feel like that should be more of a front end feel, not the rear shake I do have.

1
cofferson'01 Limited 175k and Rising•

I'd start replacing some of these bushings... I don't know how much lift you are talking here but the trans mount is a very easy swap out.

To make sure though, can you grab some good quality pics?

2
ExquisiteCheeseOP•

3 inch lift. Think it's a zone offroad kit but not sure, didn't do it.

I'll grab some once it stops raining. Plan on grabbing a motor and the trans mount tonight.

1
cofferson'01 Limited 175k and Rising•

Let's see the mounts before you go throwing money. Sorry I meant I'm not sure how much lift you for on the transfer case when you pried it.

1
ExquisiteCheeseOP•

Pulled the front drive shaft, problem persists. Gonna try mounts next.

1