How do I learn about drivers, firmware, etc?
I have a Wowtac A2S that I am learning with. I reflowed the Cree XP-L and replaced it with a Samsung LH351D. Simple enough.
Now where do I start researching driver choices? Given that this (and most of my lights) are single cell, does that mean I can limit my research to linear drivers? (I shouldn't need boost/buck, right?)
The biggest thing I'd like to change is the single click to turn on... It's much too easy to accidentally hit. I'm thinking long press for moonlight, click to cycle, long click for off, double click for turbo. Runtime is more important to me than raw output. An actual moonlight (not just 'low') is also desired.
I guess I really should just pick one and do it... Easy and cheap to do again I think? I think I'm going to try an SST-20 while I'm at it too.
Posted Jan 22, 2020, 9:31 PM UTC · edited
Here is a good, if dated, introduction to high power flashlights. The section on Runtime talks about basic flashlight drivers.
The Flashlight Wiki has a good discussion of types of Drivers.
From there, it's a question of "how far down the rabbit hole do I want to fall?". The easiest way to get the modes you want is to find a driver that already has them. Next comes altering firmware (software) to implement them. The hardware cost is surprisingly low (under $30), but you've got to learn the C programming language and set up a couple of pieces of free software. Next in complexity comes designing a driver. On top of firmware, you've got to learn electronics and how to create a printed circuit board.
While I do have the tools to cut a pcb, I hope to stick to buying boards!
Is it safe to say that for single Li-ion cell, single emitter torches, a FET driver is (generally) going to be the more powerful, more efficient choice, at the risk of software giving 100% power and frying the LED? Is an FET with 7135 just burning energy in low modes? Or not enough to matter?
Assuming I'm correct, the next step on this A2S project is to discover FET driver providers and determine why one model is superior to another. Care to nudge me one direction or another?
A quality buck-boost driver will always be more efficient than a FET, and last longer at the same brightness, since the later will waste the extra voltage to heat, and the heat will reduce efficiency even more.
Is there any buck-boost driver with Anduril or NarsilM?
Can't seem to find any.
I know someone on BLF sell the buck one, cant remember who, you can post there and ask.
I was thinking that linear drivers were the ones that use the 7135 chips to waste voltage as heat. But now looking at supplier sites, nearly all the FET drivers also have 7135 chips, at least for low. Seems sort of a misnomer as pure FET doesn't seem to be a (common?) theme.
Typically on FET+7135 drivers like the BLF A6, either the FET is on (Turbo mode) or the 7135s are (all other modes). There are two control channels. One is off, and the other is on. If the 7135 channel is being used, it may be turned on and off very rapidly (PWM). The ratio of on to off determines how bright the light appears.
(In a FET+N+1 driver, there are three control channels. 1 7135 is used for moonlight, N 7135 are used for LOW through HIGH, and the FET is Turbo).
One drawback of the FET channel is that voltage and current will decrease as the battery depletes. So the BLF A6 Turbo is brighter when the battery is more fuller charged, and with a battery that can supply lots of current (high drain).
The 7135 is a constant current source. If it’s on, it’s putting out 350 or 380 mA, and converting excess voltage to heat.