Can't decode POCSAG1200 Signal with PDW
Just got an RTL-SDR v3 Dongle last week and I've been exploring what I can do with it.
I found a signal that is pretty clearly POCSAG, but I can't seem to get PDW to work. I can see PDW is recieving the signal through VB Audio Cable, the VU meter goes up, and it even correctly identifies the signal showing PCOSAG1200 in the title bar every time a packet comes through.
For some reason it still won't show any messages. I don't even get the signal quality percentage showing under the VU meter. I guess I'm doing something wrong but I just can't figure out what I've missed.
I've tried three different versions of PDW, changing the sample rate in SDR#, in PDW and VB Audio Cable, adjusting the gain, bandwidth and volume. Nothing seems to work.
Here are screenshots of SDR# and PDW https://imgur.com/a/afPBOSX
EDIT: Thanks for the help everyone. Honestly not sure what was wrong with my SDR# setup, but I tried CubicSDR and it's working fine now.
Posted Mar 7, 2020, 7:24 PM UTC · edited
Bandwidth for POCSAG should be set closer 12,000, rather than 20,000.
I've tried 12.5k with no luck...