mr47OP•

Replaced the front pads yesterday. Saw contradicting advice regarding rotors replacement - some say you should always do it with the pads, some say that's unnecessary if rotors are in good condition. Went with leaving the rotors in place - they seemed fine, the old pads still had some life in them (3-4mm each) - so I don't think the surface of the rotors was damaged. They are also above threshold in terms of thickness.

Bedded in the brakes by following two procedures:

  1. Yesterday, took it for a drive, and made several hard (but without getting to ABS) slow downs from ~35mph) - couldn't go any faster, as it was in the neighborhood.
  2. Today, went to an empty parking lot, and did about 10 hard (again, not reaching ABS) slow downs from ~55mph).

The pictures were taken a bit later (after about a 30-minute drive) when I got home. The darker tint on the rotors actually looks a bit blue (it was more pronounced when I looked at them outside right after bedding in, should've taken the pictures then...).

Is the deposit consistent enough, or is it considered very uneven and constitutes some problem? FWIW, the brakes are absolutely quiet, not a peep from them, and the stopping power feels about as good as before.

Thanks ahead!

1
B12KHX•

The rotors look fine...

Usually if they are excessively worn grooves on the surface or if there is a lip on the outer edge then replace them... There can also be a datum mark on the middle portion that looks like a curve has been cut out of it and you can use that as a visual check mark for thickness... Not sure if that's on all rotors but it's been on the ones I've changed

I've always read not to brake harsh for the first few hundred miles to allow the surfaces to mate properly... This should give you better braking when they mate properly

Other than that, check your brake fluid level is within the range on the reservoir... Sometimes people top it up when the pads are worn and then when the pads are replaced the piston is pushed back and the fluid can overflow

2
mr47OP•

Thank you! I did take the appropriate amount of fluid out of the reservoir.

1