Unsure of PoE routing with ER-X and Ubiquiti Unifi AC Lite.

I'm not 100% on how the routing would go if I utilize the PoE injector that comes with the AC Lite. I'm wanting to run PoE with my ER-X router and AP. Would the setup go something like Cable Modem -> PoE injector -> eth 0 on ER-X and then eth 4 on ER-X -> AP. I've read some instances of people frying their cable modem if the wiring isn't done properly due to the 24V being passive.

Posted Oct 20, 2020, 1:18 AM UTC

15
jstull4•

From my understanding, you wouldn't normally inject the router. You would go from the modem to the ER-X and then feed a POE switch. From one of the poe ports on that switch, you would then feed the ap.

1
derwreckOP•

So in this situation I would just use the native power supply that came with the Ubiquiti ER-X router and plug the eth 4 (PoE out) port into the Ubiquiti AP?

1
jstull4•

Negative, I think I was jumbling information. If you inject the 24V into eth0, it will come out as 24V from eth4 and should be fine. Sorry about the confusion regarding the injector. You should be good with that setup you mentioned in your OP. Research a few videos though, it surely helped me to gain the confidence to start messing with mine.

1
shockwaveriderz•

Modem to ER-X eth0 port1 via ethernet

ER-X eth4 port 5 to AP AC lite....via ethernet

ER-X will power the ap ac lite

Eth0 port 1 is the WAN port by default

ER-X. Plugged into electrical outlet

OR

https://youtu.be/FB_1bYS22Hw

https://youtu.be/f7FeYsJqotc

1st shows you how to change wan port on ER-X from eth0 port 1 to eth1 port 2

Modem via ethernet to eth1 port 2

Then use AP AC lite injector to power ER-X on eth0 port 1 without using the ER-X power cord.

AP AC lite woukd the be powered by eth4 port 5 passthru 24v

Plus the AP Ac lite has a lan port

Option 1 is easier

1
derwreckOP•

Thank you so much, this clears it all up!

1