CBA Thermae question volume questions
I've noticed that with my Thermae that the clean signal is very quiet. The volume of the whole mix seems to go down when I turn the mix not know down, not just the proportions of wet to dry. Even with the mix knob all the way down I don't get the full volume of the signal. The volume of the repeats is so much louder than the dry signal that it makes it impractical to use for a lot of stuff that I play. Has anyone had this issue? Do I have a faulty unit ? Is there some secret setting I don't know about to adjust this? Is this a buffering issue?
Posted Nov 7, 2020, 12:50 AM UTC
45
I adjusted one of the internal trimpots to slightly increase the wet level because I felt like it was a bit too quiet. Be careful about these (DO NOT ADJUST ANYTHING BESIDES THE ONES LABELED), and only do quarter turns while testing at different mix levels until you arrive at your desired volumes.
https://i.imgur.com/73dxix2.jpg
Any chance you could repost that picture? Doesn’t seem to want to come up for me.
Done and done. Sorry about that!
That's helpful and I will try it but I'm still concerned about how much lower the dry signal is than with the pedal off.
That’s a valid concern, and I can’t say that I’ve experienced it. I’d reach out to CBA directly to see if you’ve got a potential faulty unit, assuming the trimmers don’t help. Again, less is more. Mark where they are currently set before you make an adjustment!