Lines across Miniature Base?

[ General Question ]

So, I recently did a fair bit of printing in preparation for in-person DnD (at long last!) But I noticed something odd. On one miniature, one of the last I printed, the base had lines across it (see this image).

The rest of the miniature is fine, and all my other miniatures are fine. I really don't mind the lines, painting over them has hidden them well enough, but I just want to know what could have caused them, and if I should be looking to replace some parts.

I know the picture isn't too clear, I only thought to take pictures after I'd already printed the topside. Which, to note, both the top and bottom had lines across it, but again it was only the base of the miniature (this miniature was attached to the base at print).

As ever, I printed the miniature at an angle - see here:

Example 1

Example 2

Just to note: I use an Elegoo Mars, just the regular one. Resin was Phrozen Water Washable Grey. Exposure is 65s bottom, 8s for the rest. Lift speed is 180mm and retract is 150.

Posted Sep 1, 2021, 8:38 AM UTC

36
AutoModeratorMOD•

Thanks for your submission. Please be sure you've looked through the FAQ's before posting.

FOR CHITUBOX 1.9/ PRINTER FIRMWARE ISSUES, PLEASE MOVE YOUR DISCUSSION TO THIS THREAD: CHITUBOX 1.9/ LATEST FIRMWARE MASTERPOST

For troubleshooting posts - please ensure you include printer model, what resin type you're using, print settings you've tried (if applicable) and of course what steps you've already attempted to resolve your issue - please note, it is best to include screenshots to help us get a better understanding of your issue.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1
WeedBauer•

I don't fully understand what you need but I can say one thing. Those bases are not properly supported and therefore can be an issue. On resin printers you usually don't have to replace anything but FEP and the screen but you might want to grease the leadscrew once a month

1
ShadowReaperTOP[ :Mars: Mars ]•

The Z-axis is greased just fine, and things are working. I'm not particularly bothered about the base not being completely circular.

What I'm asking about in this post is specifically the lines across the base - they shouldn't be there. I've printed multiple of this model, and it only appeared on the last one, and specifically only on the base (but on the top and bottom). The picture isn't great, but the lines are visible and span the base from one side to the other.

1
NotMrMike•

This is a wild guess, but my theory (based on the angles of the lines) is that as each layer cures, and supports are added, the base gets a teeny bit extra-cured as UV light leaks through the liquid resin a little, with the exception of areas shadowed by supports. So those lines are just slightly less-cured than the areas around them.

I wouldnt consider is an issue, just interesting. Probably completely invisible when painted over.

1
Kompy_87•

I had this happen to me before. Take your sliced proton file and import it back into Chitubox and zoom in on the base. You might notice the lines in the base are actually *part of the print file*, meaning it's not some quirk of the printer itself causing it.

If this is the case, a few things you can try:

Turn on anti-aliasing.

Rotate the print if it's happening on visible areas you care about (under the base will go unnoticed so it's fine)

Reduce layer thickness/increase resolution (will result in longer prints times though)

Sand down the lines.

Try a different slicing software.

1
ShadowReaperTOP[ :Mars: Mars ]•

I printed this model 4 times (3 were on a different print) and the other 3 didn't have the same lines, so it's definitely not the model itself. Thanks though!

1
[deleted]•

[removed]

0