sirwindomearle•

they sell what are called “drywall shims” which are essentially long strips of cardboard that you can use to fill in these kinds of gaps.

6
highgrade86•

This is a plumbing Sub not a tile sub. You will have better luck at r/tile

3
kokirig•

Yep this isn't a plumbing problem, framing/tile problem

Just saying- you might get some ideas to fix it, but this isn't the place for this

2
Hardhitting13•

It is if you’re installing a enclosure. I learned the hard way 😪

2
kokirig•

Oh yeah I'll give you that, sorry I haven't installed the fiberglass units in awhile... If the framing isn't perfect they are a nightmare.

Shims are gonna be your best bet outside of full on fixing the framing. There are techniques for pulling bows and such out

1
Hardhitting13•

Yea I’m no framer. Fuck enclosures

2
ScoobaMonsta•

This is not a plumbing issue. It’s a building issue. Where is the carpenter? The plumber shouldn’t be putting on the wall lining. This is the responsibility of the carpenter/builder.

1
Rexan02OP•

Thanks, that is how the framing was when I pulled the sheetrock off. As this is a diy job. I am all of the things.

1
ScoobaMonsta•

I see. Put a straight edge across the wall diagonally from corner to corner. You could use a string line also. Then you can measure how far the string line is from the face of the studs. Pack out each stud with a non compressible material. I find thin 3mm ply is good for this. But you might have a better product in mind. Pack out the full length of each stud and the noggins. I would glue and fix with a finishing gun. Check with a straight edge. Good luck 👍

2
avbadal01•

Pssssst…..you’ll never see it…

1
Rexan02OP•

I'm more concerned with bowing the board when I secure it

1
Hanky-so-Stanky•

Try wet shimming the walls with mortar or getting the car board shims.

1
avbadal01•

Liquid nails a few shims to the stud and you’ll be good

1
boringjoemauer•

Shouldn’t that wood at the base be treated lumber?

0
Rexan02OP•

I don't think so.. its getting a pvc liner, mortar, then goboard on the walls, then everything gets multiple layers of Aquadefense. If water gets in there treated lumber won't save me I don't think

3
avbadal01•

Treated lumber is not necessary.

2