Rexan02

u/Rexan02


r/BackYardChickens•

So one of my barred rocks has been getting her face pecked by the other chickens.. my son and I went to put some blue-kote on the wound to get the other chickens to let it heal.. well a major drip ended up staining her face purple and the other hens immediately started pecking at her. Had to put her in isolation. Any idea as to how long this stuff lasts? It's all over our hands and it seems about as bad as wood stain!

21


r/HomeImprovement•

Hey all, so I plan on dry packing my shower pan this morning and just realized I may not have enough to do the whole pan. I have 7 bags of sakrete sand topping, and am afraid I will be short. Unfortunately I cannot source that specific brand nearby, would it be a problem using the quikrete green label stuff also? Like mixing a bag of quikrete and a bag of sakrete together in the mixing pan to get what I need if I'm short?

02

r/slaythespire•

I'm currently in low ascensions with all characters, and I find myself ending up with decks that are 25-30 cards by the end of Act 3.. is this generally too bloated when trying to move up in ascensions?

912


r/homeowners•

So I am finally painting my garage and cleaning things up, and I notice that there is about a 1/8" or so gap between the concrete slab and the raised concrete edge/curb that the sill plate and walls sit on. Is that something that's OK to seal with caulk/silicone/concrete sealant?

12

r/Cartalk•

Hey all, I replaced the pads on all 4 wheels of my wife's 2012 Odyssey, but didn't replace the rotors. Would it be a problem replacing the rotors without re-replacing the pads? We've probably driven 500 miles or so on the new pads.

06

r/hvacadvice•

Edit: turns out to have been a bad motor. Replaced motor has been running a while and is not getting hot. Thank you all for the advice!

Hello,

I have a Bryant unit from 2002, and the capacitor and fan motor went the other night. I replaced the (bulging) capacitor and the fan motor. All connections are in their proper place on the capacitor (fan to fan, compressor to herm).. the unit starts right up and cools appropriately. Then the fan motor shuts down and the compressor keeps running. I turn the breaker off to the condenser. After a while I can turn it back on and repeat until the fan heats up again.. any ideas?

Capacitor specs match exactly

Fan motor specs match exactly.. its pretty

223


r/Tools•

Hello,

I was hoping somebody may be able to help me out. I have a Makita XSL07 12" miter saw, and the blade is "canted" by about 1/16th of an inch. Meaning if I cut a 2x6 flat, the cut will be 1/16th off between the top and bottom, so a 25 inch piece will be 25" at the top and 25 1/16th at the bottom.. any idea how to fix this?

12