Question about bed leveling and starting g-code
Hey guys, I just got an ender-3 S1 pro last week and I'm not super happy with the quality of prints right out of the box. As some background, here's what I've done so far:
-
Checked the frame for square, checked belt tension, checked rollers (one or two of the individual rollers are tighter than I'd like, but the corresponding eccentric bearing is already at max adjustment)
-
Before powering up the printer, moved the adjustment dials to ~midpoint of their travel and manually leveled the bed using some paper
-
Powered up the printer, preheated to PLA temperatures, ran through the "aux bed leveling" part of the menu and manually fine tuned it again using paper
-
Ran the auto bed level function
-
Adjusted the z axis offset using some paper
I then started going through the teaching tech calibration guide, but after their generated g-code crashed the nozzle into the build-plate and scraped it all the way across to another corner during the bed leveling portion, I decided to take a step back and actually figure out what's going on with the initial startup sequence.
So on to questions:
-
Is the Z axis offset always in effect? Is there any g-code command I need to watch out for that'll reset/disable/ignore it?
-
When is the auto bed level mesh in effect? i.e. if I put the printer back into that "aux bed levelling" mode, is it using the ABL mesh or does it revert to absolute coordinates? I don't want to find myself chasing the ABL function in a loop.
-
What sequence of g-code should I normally be doing at the beginning of a print as far as bed leveling goes? I'm assuming G28 to home it, then M420 S1 to load the mesh? I've also seen examples that do G28, G29 to perform an ABL, then M420 S1. Is the M420 required after the G29 for it to actually use the ABL data?
-
As a rule should I always be auto-leveling before a print, or is it just kind of an every once in a while thing?
-
Is there a standard way to visualize the ABL mesh that my printer is generating?
Posted Sep 30, 2022, 6:41 PM UTC · edited
G29 creates a new mesh. M420 S1 loads the saved mesh. Use the latter directly after G28 like you currently are. Ill rerun my mesh every few days as a maitenance procedure, but it honestly doesnt change. Make sure your bed is preheated to the temp you run at when you make the mesh. The nozzle also needs to be preheated for the z-offset.
The z-offset is the distance between your cr-touch probe and nozzle. It should be always be active with the above mentioned gcode. Your nozzle should never be closer than a layer heights distance to your bed. So if it is scraping your bed, something if off by a lot. Maybe post your start gcode?
Get professional firmware to get a better mesh and view it.