BHRobots

A couple weekends ago I built this keyboard speed-run style. I wasn't really planning on it, but I've been stuck in iterations on my own keyboard design, and I just wanted a new, simple keyboard to try out. Friday afternoon on a whim, I searched and found this ScottoFly design (thanks u/Joe_Scotto), and holy hell, I have everything I need, I could handwire that thing quick.

Started printing the plate immediately, scrounged up an old pro micro and the rest of the components, discovered that the pro micro was dead. Have a pile of RP2040 pico boards, let's just modify the helpfully-provided STEP file so that controller fits. Start the modified case print to run over night.

And looking at

A couple weekends ago I built this keyboard speed-run style. I wasn't really planning on it, but I've been stuck in iterations on my own keyboard design, and I just wanted a new, simple keyboard to try out. Friday afternoon on a whim, I searched and found this ScottoFly design (thanks u/Joe_Scotto), and holy hell, I have everything I need, I could handwire that thing quick.

Started printing the plate immediately, scrounged up an old pro micro and the rest of the components, discovered that the pro micro was dead. Have a pile of RP2040 pico boards, let's just modify the helpfully-provided STEP file so that controller fits. Start the modified case print to run over night.

And looking at

A couple weekends ago I built this keyboard speed-run style. I wasn't really planning on it, but I've been stuck in iterations on my own keyboard design, and I just wanted a new, simple keyboard to try out. Friday afternoon on a whim, I searched and found this ScottoFly design (thanks u/Joe_Scotto), and holy hell, I have everything I need, I could handwire that thing quick.

Started printing the plate immediately, scrounged up an old pro micro and the rest of the components, discovered that the pro micro was dead. Have a pile of RP2040 pico boards, let's just modify the helpfully-provided STEP file so that controller fits. Start the modified case print to run over night.

And looking at

Problem up front: I flashed QMK rev1 default, but can't reset into bootloader. Suspicion is that bootloader was set to caterina, will I need to reflash the bootloader and then modify my QMK config to use atmel-dfu to fix it?

More story:

Now that I have an adept, I thought I'd try updating my olde classic trackball to the latest QMK and enable that delicious DRAG_SCROLL.

Following this guide (and a few others): https://github.com/ploopyco/classic-trackball/wiki/Appendix-D%3A-Programming-QMK-on-Older-Ploopy-Devices

I managed to connect to the ICSP pins and flash the atmel bootloader Then I flashed the rev1 default QMK firmware/keymap, but now I want to move some buttons around and en

I just noticed today on an article that was put in my face by Google, about tech industry stuff, that the news site had "Bonneville International" in the footer. The site in question is mynorthwest.com. I did not expect church ownership of the news in this area, but apparently they own some of it.

Bonneville is owned by the cult, and lots of things are owned by Bonneville.

Yeah, you know what? Fuck that noise. I was told the "bath water" was pure and clean, so a baby would have been clearly visible. If your bath water weren't so damn filthy I might be able to see the "baby".

Then how are you going to know that there's NOT shit in the brownies?