Hey everyone,
I'm working on troubleshooting an issue with my Whirlpool electric range (model WFE320M0ES). The front right burner was having runaway overheating.
So, I replaced the infinite switch with new identical part because I've read runaway heating usually means a bad infinite switch.
After installation, I noticed that when the burner is set to high, it cycles rapidly—on for about 1 second, off for 2 seconds. It doesn't hold a steady high heat as expected. When set lower, it barely turns on at all.
When observing the new switches with the back cover off, I noticed a small arc/flash near the bimetal strip right before the burner cycles off. This happens with both the new switch a
