DWhispers9

Hello everyone, I would like to ask anyone for some assistance, I am currently trying to build a printer using ender 3 v2 chassis with an SKR Mini E3 V3, EBB SB2209 (rp2040) CAN for stealthburner toolhead, BTT U2C and a BTT Pi4b+CB1. Everytime I install and setup firmware then configure printer cfg everything works well. The only issue is after almost an hour printing I get an mcu ebb shutdown error. Changed the BTT Pi4b+CB1 for a Raspberry Pi Zero 2 W and I still get the same issue. Could the error be coming from the SKR Mini E3 V3 even though it says mcu ebb?

Hello everyone, I would like to ask anyone for some assistance, I am currently trying to build a printer using ender 3 v2 chassis with an SKR Mini E3 V3, EBB SB2209 (rp2040) CAN for stealthburner toolhead, BTT U2C and a BTT Pi4b+CB1. Everytime I install and setup firmware then configure printer cfg everything works well. The only issue is after almost an hour printing I get an mcu ebb shutdown error. Changed the BTT Pi4b+CB1 for a Raspberry Pi Zero 2 W and I still get the same issue. Could the error be coming from the SKR Mini E3 V3 even though it says mcu ebb?

Hello everyone I am in need of major assistance. I have a SKR Mini E3 V3, BTT Pi4b + CB1, EBB SB2209 CAN, Knomi 2, BTT U2C, BIQU Microprobe and for the love of all that's mighty I can't get klipper running or working. Everytime I try and flash firmware it can't find something, it's always something. Can someone help me out with a breakdown on the steps to make and flash firmware.

I have an issue and would like to know if BIGTREETECH can help me out. I have and SKR Mini E3 V3.0 with a SKR TFT35 E3 V3.0 a BLTouch and a BTT Smart filament Sensor for my ender 3v2. I have been having issues with compiling the firmware and getting everything to work flawlessly. After a perfect compilation of the firmware when trying to level the bed the nozzle kept smashing on the glass bed, issue was fixed by commenting Adaptive_step_smoothing. Now BLTouch works flawless but now my prints stop midway or at almost complete with a m1 stop error message. After a couple attempts i notice and heard a spark from the board, when i looked the VIN pin looks to be shorted and now it will not print