Ferrule

u/Ferrule




r/10mm•

I'm getting ready to order a bar-sto barrel for my G40 and start the wait. I've pretty much decided to go with a semi-fit instead of match target because I probably can't really out shoot the factory barrel yet as is, so I highly doubt I'd benefit from the extra hours of fitting with the MT vs SF. I've done some minor fitting for 1911 stuff, but from what I've read the match target has a LOT of material to remove, whereas the semi-fit will most likely just need a bit of stoning and maybe none at all. Mostly want it for the tighter chamber for reloading as both my glock and Alpha Wolf barrels bulge and smile brass a bit with top end loads, but if I'm buying another another aftermarket barrel

14

r/Starlink•

How would I go about adding an access point in a metal outbuilding with ethernet backhaul ~100' to the starlink router in my house, and have seamless handoff between the two? I have v2 dishy and an ethernet adapter. Assuming I can't just buy something like this and direct burial cat6 to the shop to the access point to achieve seamless handoff.

If not, can I use the official starlink mesh router in the shop, and cat6 from it to the router in the home for backhaul, or does the starlink mesh router only use wifi for backhaul to the original router? I only get 1-2 bars in the shop, so I'd rather run data out there with ethernet if possible, if

17

r/polymer80•

I built a G20L a while back on a PF45 frame with all lone wolf parts but the frame. Long slide custom built with their slide configurator, alpha wolf long threaded barrel, 507c, the works. It's accurate, but having issues feeding issues probably 30-50% of the time with any ammo I have tried so far. It looks like the edge of the case may be hanging on the top of the chamber but not sure why.

If I bump the magazine on the base pad when it hangs up it will finish chambering the round 100% of the time...any ideas of common problems or things to look at?

I really like the feel of the p80 frames over the oem or I'd have just bought a g20 and swapped the big boi upper over to it to try. Also ju

824



r/NFA•

What would be a good option for a 12" 458 socom can? I was looking hard at the rugged obsidian 45, but after I checked with them, they said it was rated for a 16" or longer barrel and subs only.

That leaves the hybrid, which SiCo rates down to a 16" barrel with 45-70. I'm awaiting a reply on what they'll cover it down to on a 458 socom. Thinking it would be less, due to less case volume on the socom, but we'll see.

What other options am I missing? Haven't looked into the Bushwhacker a ton yet, the vers 458 is too big and heavy. Planning to leave whatever it I go with direct thread.

Something like a big bore Nomad would be ideal, but have yet to see any movement on a 458 can from dead air

410