Huntred

u/Huntred



r/hometheater•

Overarching problem: Content will not display to and through Epson projector via either HDMI ports.

Specifics: Projector will no longer display video from any source plugged into either of 2 HDMI ports. Receiver will no longer output video signal via HDMI. Under most circumstances, will still output audio to speakers.

Setup

Receiver: Onkyo TX-NR696 (HDMI 1 and 2 output)

Projector: New Epson LS500B (HDMI 1 and 2 input)

Source 1: AppleTV, model A1842 (HDMI out)

Source 2: Comcast Cable Box (HDMI out)

Source 3: Sonos (Audio only)

Power Management - Cyberpower 950VA

TEST EQUIPMENT

Laptop with HDMI out

Asus VW266 1080p monitor

Background: Earlier this summer, I found I was having mor

111


r/boardgames•

So being curious about CO2 levels around me, I bought a digital detector and took to leaving it out in various rooms in the house — bedroom, kitchen, living room, etc. Recently I left it out in the middle of my gaming table during a session and was pretty surprised by the amounts that were being recorded. There were 7 adults in total playing for about 6-7 hours in a large basement room (15x40) without active ventilation or open windows (was pretty cold outside to open them.)

Towards the end of the session, I pulled the detector away from the center of the table and put it to the side of the room just to get a sense of the distribution/diffusion of the CO2 and obviously it went down a bi

09