Live_Distribution
u/Live_Distribution
I have an E3v2 purchased with CR Touch which works perfectly with Creality original firmware.
I installed Jyers BLTouch Firmware, level the bed and verify that all 4 corners are levelled, which I go around each corner one by one and also after levelled I check 5 times back to back without changing anything.
I Select Home All or Home Z and when I go back into to Manual Levelling and choose any corner the Z axis moves down but not the same height I just levelled to?
Here are my steps I do just to make sure I am not doing something wrong:
- Pre-heat PLA bed and Nozzle wait ~ 5 mins until hot, Make sure Nozzle is clean.
- Adjust my Z Offset using A4 paper and save then I Ho
I am a proud owner of a Ender 3 V2, I have Jyers firmware version 1.3.5b. I've setup everything correctly and everything looks fine but after a print the mesh settings are no longer there, when I select view mesh it says no mesh found. But if I reload my settings the mesh settings are loaded all okay.
The settings are saved in the EEPROM 0 below is my gcode.
G29 A ; Activate UBL.
G29 L0 ; Load default mesh from EEPROM.
G29 F10 ; Fade corrections over 10 mm (uncompensated above that).
G29 J2 ; Get the bed tilt in a 2 x 2 grid instead of the default 3-points.
Is it normal for the Mesh Settings to go after each print ? I wonder if I should save it to a different slot do I just cha
Hi All,
I have MeshCentral2 on Ubuntu Cloud with MongoDB just installed, the issue I seem to have is the device status is not being refreshed unless I manually restart the service of MeshCentral.
Ie if device goes offline it does not update on the website and it shows as it's still powered when in fact it's offline.
I waited 20 hours and status has not changed.
Is there is a setting I need to add to config.json so it refresh say every 30 seconds of added device status?
Thanks,
Gokhan
Hi,
I want to know how if its possible to install the MeshCentral agent unattended on Windows 10 via command prompt running in Administration, that I can download the agent.exe with wget style to pull the installer in to windows and install it on the background unattended?
We have 100s of NUCs running off site and we have shell access of Command prompt if i could install the agent via this method it would be very good.
Thanks All Gokhan
Hi, I am using Hetzner Cloud server and the service is excellent, the only issue is the speed per server is only limited to 1gbps, is there a way to load balance or split the traffic to other servers ?
Have one server for the keys and user connection and other servers to forward traffic and once it detects say 3 connections on each server to switch that use to another user with low connections.
Any suggestions?
Thanks,
Gee
I just received my QC pictures of my ZZF V2 Submariner I am not to sure if the 12 o'clock luminous dot should be yellowish like that?
It's my first rep so I have no experience with QC I would be happy if you can check this out for me please.
Thanks in Advance
Gok
You've reached the end of this feed.