RedneckScienceGeek

u/RedneckScienceGeek


AI and dangerous advice

📊 Analysis / Opinion

I just asked Google's AI a question about processing mixed hazardous waste, and its recommendation was a major safety hazard (mixing bleach with a 95% ethanol solution). When I questioned this advice it did the usual "I apologize, you're so smart!" BS. It led me to question the AI on potential legal issues for Google with it dispensing dangerous advice and philosophical questions on whether AI should be allowed to dispense potentially lethal advice.

I then asked what it would do going forward to prevent similar issues. To which I received the following response:

"To prevent errors like this moving forward, the focus must be on structural changes to how I process and cross-reference hig

011


r/Bamboo•

I'm looking for a bamboo species that I can grow on my property in Vermont, Zone 5A, that I can harvest as poles for gardening. Ideally I'd like up to 1" diameter poles, though I do have use for smaller poles too. I don't want to have to fight it spreading constantly, so I understand that I would need a clumping species. Are there any cold hardy clumping species that get large enough to harvest as poles? Thank you!

13

r/HomeImprovement•

Photos here: https://imgur.com/gallery/what-am-i-doing-wrong-porter-cable-pce980-tile-saw-lbCxGL5

I've been trying to cut tile for a laundry room renovation, but I can't get the tile saw to cut straight. I'm using a Porter Cable PCE980. I have aligned the fence and the rail that guides the table as described in the manual so that the blade is square to the fence over the full travel of the table. I have verified that my square is square. As I cut, it runs fine until I get past the center of the blade, then it acts like I'm pushing into the blade at an angle. The right end of the tile moves away fr

34


r/HomeImprovement•

I have a couple holes through my foundation for my well pipe with the original pump wire, and an additional wire that was put in when lightning fried the first wire. These holes occasionally allow water in when we have big storms. I've sealed larger foundation holes with hydraulic cement, but I don't see any way to get it in deeply enough to do anything around these pipes/wires. Is there a better product or application method that will allow me to seal deeply into these small spaces?

https://imgur.com/a/KdcMiS6

10

r/Snowblowers•

I have a Honda HSS928A snowblower that will not start with the battery. Pull start works fine. I can hear starter click, then a high pitched squeal when cranking. Sounds to me like starter is kicking out but not engaging. Battery is at 12.7V. Meter from starter terminal to negative terminal on side of engine reads 4.5V when cranking. Meter from far terminal of "starter magnetic switch" to battery negative terminal reads 5.3v when cranking. Snowblower was refurbished after being submerged in a flood summer '23, but worked fine last winter. I cleaned all contacts that I could find.

Am I right that I should be getting the full 12.7V (or close to it) all the way to the starter? Thinking I

14

r/Snowblowers•

I got an old Honda HSS928A snowblower this last winter, and I'm trying to move it about 20'. It is out of gas and I'd rather leave it that way. Moving the drive lever to the neutral position does not allow it to freewheel. I found the video linked below that shows an HS928 has a "transmission release lever," but as you can see in the linked photo, my HSS928A does not. How do I disengage the transmission so it is freewheeling?

https://www.youtube.com/watch?v=4AE6G2rlo78
https://imgur.com/a/V2ReMOg

21

r/AskALawyer•

We have been contacted by someone who is considering buying the property behind ours. They would like to run utilities down the side of the right of way that runs through our property. When we bought the property, we were under the impression that the right of way was for egress/ingress only.

Our warranty deed and the warranty deed for the previous owners of the property both state, "the within conveyed premises are subject to a right of way for ingress and egress over an existing wood road, 20 feet in width, for the benefit of lot #2..."

The warranty deed for lot #2 states, "Also conveyed herewith is a right of way for utilities, ingress, and egress, including vehicular traffic over

12


r/AskElectronics•

I know just enough about electronics to get myself in trouble, so please bear with me/ELI5. Here are a couple photos that may help clarify my issue:

https://imgur.com/a/AxZXdGW

My Ryobi light's switch has been getting progressively more moody as the years have gone by. Successive presses of the button are supposed to cycle the light from off, to fully on, to 1/2 the LEDs on, to the other 1/2 of the LEDs on, and back to off. the button now only works about 20% of the time, so I decided to fix it. I opened it up and verified that the switch on the small circuit board is the issue, not the mechanical connection to the button above. Pressing the switch direc

12

r/Snowblowers•

The handlebars on my snowblower are so low I have to bend forward a few inches to hold them, and when turning I have to lean down with my hands near knee level. My back is too old for that shit, so I added a 7" lift to the handlebars. Used a bit of conduit and a strap of stainless that i had kicking around. Dressed it up with heat shrink fishing pole wrap. Feels good and solid, and gives me a lot more leverage to turn it.

Also replaced the impeller and added pieces of tire sidewall to close the gap around it so it throws better. Tuned up the engine, lubed where it needed lube, added tire chains, and gave the housing a rattle can paint job. Looking forward to this coming winter.

12