actmoon

As above. I’m not too sure if I’m able to attempt to fit it on a 45cm depth shelving as the wiki does not provide the measurements of the actual feet. I understand that it is actually slightly more inwards.

Can anyone explain why Arachne tends to produce worse off seams and wall quality when compared to classic?

I’ve given it quite a lot of tries and that’s the conclusion I get from my prints consistently.

Hence I tend to skip arachne unless I’m printing something that needs thin walls.

If anyone has some settings tips to share to make Arachne print better please do share!

Hi. I’m running the latest orcaslicer for a Bambulabs P1S.

Currently I’m unable to get the first layer to adhere to the print bed. The purge line however prints perfectly.

The plate has been washed, autobed leveling has been enabled.

I’ve tried normal models and ALSO the flow calibration model (just in case it was an issue with the model). Neither stuck to the bed except for the purge line.

HOWEVER, running the flow calibration on bambuslicer had no adhesion issues and everything stuck to the bed nicely.

My guess is there’s somehow a bug or a setting I accidentally touched that disabled the saving of bed leveling, or adjusted the z offset.

Any suggestions are welcomed!

Hi,

​

i've followed the instructions as per https://github.com/mainsail-crew/moonraker-timelapse , but the timelapse option is not showing up in neither the settings page, or even under update manager.

​

anyone has any clues where could i have possibly gone wrong?

​

thanks!

[bltouch]

sensor_pin: ^PB1

control_pin: PB0

x_offset: -44

y_offset: -7.5

z_offset: 1.25

​

[bed_mesh]

speed: 120

horizontal_move_z: 10

mesh_min: 46, 7

mesh_max: 204, 222

probe_count: 5,5

algorithm: bicubic

fade_start: 1

fade_end: 2

fade_target: 0

​

​

EDIT: Printer is an Ender 3v2. bed size 235 x 235

Hi. I just got onto Klipper recently and everything was finally tuned and printing well.

But I noticed that my bltouch would sometime deploy mid print, causing the pin to hit the print before retracting.

Anyone has any inkling of possible causes?

Thanks!

EDIT: I checked the wires & reconnected them just in case. also slightly screwed in the depth of the screw top of the BLTouch. everything seems to be working for now. fingers crossed. thanks everyone!

I tried twice and it did not stick to the build plate at all.

Tried 30s base layers, normal layers 3.5s

As above.

​

totally new to this. i saw a variety of flexible plates online, but none matched the supposed bed size ( 120x80mm)