akadmin

I'm in a position to build a new data center where I'll be advertising a /24 to each provider, and I am trying to figure out what the best approach is for ISP failover.

Architecture:

Each ISP lands on its own dedicated router (eBGP peerings across respective /30s, as_path prepend on backup isp), then those routers will iBGP peer to the firewall, with MED200 for the backup ISP, and MED100 for the primary ISP.

Naturally, I can take a default route from the ISPs, and if the primary ISP goes hard down, BGP times out and that default route is pulled. However, this doesn't cover "brownout" conditions where the peering stays up. Of course, an admin can go in and shut the BGP session to

Coming from the 81-83 split into the swatara area, there seems to be a haze and a strong smell of smoke. Anyone know what's going on? I smell it inside the office building I'm at.

I shaved my head like 7 years ago and have been clean shaven ever since. However, ever since then I have had an issue with an oily scalp. It is embarrassing. I literally leave grease marks on my head rest in my car and on my pillow cases. If I wear a headset I get grease on that. If I happen to touch my head I have oily hands and I have to go wash them with soap.

Of course I can go wash my whole head in the bathroom at work midday but I don't always have the opportunity.

Is there any cures or hacks that you guys could recommend??

How does AnyConnect choose which XML to use if multiple exist on the PC? Looking to update a setting and deploy from the head end. The file name will be different ideally.

When I rescued my boy at 6 months old he was missing an eye (surgically) and was sneezy. It got worse over time and turned into sneezing large boogies all over the house -- sometimes I can't believe they fit out his little nose. He will eventually get post-nasal drip and swallow a lot, which then causes him nausea and coughing. Once he gets to this point of discomfort, I request antibiotics from the vet and it clears him up completely.

After many many vet visits of trying to figure this one out, they've diagnosed him with asthma (I think this diagnosis ignored half of the story and is incorrect) and have me giving him prednisolone as a solution.

A). Pred for life seems irresponsible

I'm having a tough time researching this one :( I think the answer is "no", but wanted to check here.

I'm using RADIUS-based MFA against an NPS server / Entra ID extension from a Cisco VPN server, and for a few reasons (mostly for simplicity due to 4 internet connections and 4 different possible public IPs) I'd like to keep this setup rather than migrate to SAML auth - HOWEVER - our infosec department recently enabled the "location/code" based MFA, and it doesn't seem to include this particular authentication flow -- this is when you not only get the "approve/deny" push notification, but also you see a map with the requestor location as well as a 2-digit code you need to enter.

Is it poss

Source: It's been almost 9 years of "we got him this time"

Hey guys. I hope you don't mind the questions - I just want to be completely sure before I spend a bunch of money.

Right now I've got a couple REALLY old AGM batteries that aren't up to the task anymore, so I'm in the market for a new battery. I've read some good things about lithium batteries, but I'm still not quite sure what to get.

I'm pushing a 14ft aluminum boat with a 55lb thrust minn-kota, 12v, with ~430lb max (two people), including gear. I am looking at a 12v 100Ah LiFePO4 battery, around 280 USD. I read that I should get ~2hrs of max thrust power out of that, which obviously translates to a full day on the lake at much lower speeds without any worries of having to paddle b

What do you all do for ISE authentication when it comes to a trunk port for a locally-switched WAP?

If you do nothing, the theory is someone could stand on a ladder and plug their laptop into your WAP port, get on the native VLAN and do damage.

I considered 802.1x / MAB but when you locally switch wifi traffic, all the MACs end up on that port and the switch tries to authenticate them even though they already authenticated against the SSID. Seems like this technology doesn't work for this use case?

I guess our only defense here is to have a dedicated native WAP subnet with ACLs applied? I'm planning on going with Meraki WAPs so before I add a bunch of ACL entries to my fleet I figured

Got this truck in May, but this problem has only started since the cold weather started.

After letting it sit a few days, I go to use the truck and it's got no juice. Not even the odometer lights up when I open the door. I hold the radio power button in until it turns on and the truck comes to life. Battery has a full charge (it's only like a month old). I've only had it happen twice so it's not like I can recreate the issue for the shop without some luck. No codes or anything.

Any ideas? Initial research makes me think the BCM is failing, but wtf.

I put a good bit of thought into this configuration, but it's my first venture into QoS outside of upload shaping for class-default :). I want to leverage NBAR (first time using NBAR) so here is my first shot. Any of you gurus see any glaringly obvious mistakes or things you'd do differently?

Note: this policy is to be used in DMVPN per-tunnel QoS, so these policies will be applied OUTBOUND from the DMVPN hub router to the spoke routers.

Goals/requirements: Shape all outbound traffic to the spoke link speed (50mbps), but create a 30% reservation for "high priority traffic", police "low priority traffic" to 10mbps, and fair-queue the rest so one big flow doesn't prevent small flows from

I kayak or boat fish lakes and quarries all over central and eastern PA. I know there are walleyes, smallmouths, stripers, and musky in a lot of these places, but I seem to exclusively catch largemouth.

I fish a lot of weightless t-rig senkos and whopper plopper 110s/130s. I've thrown divers, chatters with swim trailers, buzzbait, and weighted creatures/senkos for countless hours as well. I don't go early or stay late so I do miss all low light conditions unless overcast. I mostly throw at the bank from like 20y out or run topwater over weed beds.

How do I catch these other species?