fphazer

u/fphazer


r/WireGuard•

Has anyone had success securing the wireguard private key on windows with GPG?

I found this post online that would prompt for a password when a tunnel is established, but this sort of thing does not seem to work with the windows client.

https://serverfault.com/questions/1135917/wireguard-config-protection

trying to add this to the POSTUP does not seem to with the client, if finds and error because the private key is not set when the config is saved. Seems like I cannot add it after the fact.

wg set wg0 private-key <(gpg -d private.key.gpg)

And I did not have luck running this command from the CLI in windows.

14

r/RockyLinux•

This is a new to me issue, trying to install the Rocky 9.1 minimal iso on a VMware VM that has Haswell Xeon CPU, I get kernel panic error that x86_64-v2 is not detected. I am not sure if this is a bug or a missing setting surfaced from VMware about the VM. Seems like x86_64-v2 support begins at Nahalem circa 2009 and my CPU which is Haswell came out around 2014, so x86_64-v2 should be supported. Any suggestions of how to get past this would be great? (Also I have had success installing on Sandy Bridge without an issue, that chip came out around 2011)

Thanks for any insight.

62

r/networking•

I would like to set up a tftp server in AWS to provide a central place to copy equipment configurations to, from network equipment I have all over the world.

I am able to connect to the tftp server on udp/69 but the data transfer to copy the data on an alternate udp port seems be blocked. I have permitted all udp ports on the security group for the instance, but not luck. Does anyone know of any other location in AWS / VPC that may block udp traffic of a tftp server?

I was able to verify that the tftp server does work. I am able to transfer data via tftp within a VPC subnet. It does not work when the traffic is coming from outside the VPC

Also I tested two different tftp servers, tftp64

236

r/networking•

I would like to have a 40Gbps cross connect run in a data center that connects between the 40Gbps QSFP+ port on my switches. I don't know the correct terminology to request this? Is the term MTP? do I request OM3 or OM4 fiber with an MTP connector? (This would be Multi-Mode rather than single mode since it is less than 100 meters)

I have dealt OM3 LC SFP+ fiber cross connect for 10Gbps and QSFP+ DAC cables for 40Gbps, but those have limited length. This is the first time I have had to deal with a longer run that needs 40Gbps and I am not quite sure what to ask for from the Co-Lo. A single 40Gbps run seems better than 4 x 10Gbps OM3 LC cables that connect to a QSFP+ break out cable.

Thank

1419

r/ToobAmps•

I am looking for some guidance troubleshooting the Fender 5e3 Deluxe circuit to work well with humbucker pickups. In short, the amp sounds great with single coils but humbuckers make the speaker ‘thwack” which does not sound good. I have the amp volume set at 10 and the guitar volume set at 5, there is yummy tube distortion, but always a little “thwacking” from the speaker when a bass heavy chords are played. (This is an amp that I built from the 5e3 schematic from scratch)

I understand that the circuit was designed for fender guitars in mind so maybe this is a futile objective. From my reading it seems like the “Lo” impedance/gain input should accommodate for the higher voltage generat

1316

r/Windows10•

Sorry to post a bug issue here, but I have not had much luck fixing this issue.

A few weeks ago if found my UWP apps interface all became unusable. The issue behaves as if the interface is constantly receiving input.

Example: Microsoft Edge, if I click the "..." menu in the upper right the menu appears and disappears constantly, and the button flickers as if receiving constant input. Photos, Mail, calculator, all experience the same behavior where I am unable to interact with the interface.

The Settings Panel does work, and does not experience this issue.

Is there some way to default out the UWP interface settings?

I have tried the "Settings --> Updates and Security --> Troub

22

r/Leftyguitarists•

I play lefty strung righty, and never fail over the years people are amazed that one can do that.

So I compiled a list of guitarists that play lefty strung righty. Feel free to add to the compilation.

Also I would love for there to be a term to label this. I find it is a challenge to describe every time and feel a label would be good for this technique. Suggestions welcome!!! (I feel something that referenced Dick Dale or surf guitar would be great)

Here is the list:

Dick Dale https://youtu.be/Fwx2pephwKU?t=1m4s

Albert King https://youtu.be/gZB57b3lPQE?t=3m36s

Doyle Bramhall II https://youtu.be/DafRP-DWZ4w?t=46s

Eric Gales https://youtu.be/mo6ktz4Zz6U?t=1m43s

Bill Staines https:/

110

r/ToobAmps•

[I saw this post on r/guitar](https://www.reddit.com/r/Guitar/comments/5qa97l/question_why_are_99_of_guitars_regardless_of/) and felt it can also apply over here on ToobAmps.

I have always had concerns about legal issues regarding circuits and cabinet designs when building an amps. I have built a few amps derived off of Fender circuits, and have wondered whether I would be in violation of any copyright if I sold the amp? Or is this a non issue since these fender circuit are derived off of RCA circuit originally which were handed out for free to encourage people to build circuit that use RCA tubes.

Also, cabinets, why do so many amps look like fender tweeds? I like the look like everyone

49

r/linuxaudio•

General audio input question (newbie)

I am planning on purchasing a new USB sound card for microphone inputs. I have a general question about system setup, as I would like to record multiple mics, say 2-4 mics. Is it possible to connect to multiple USB devices for input with a program like Ardour?

For example, I have a 2 port Creative EMU 0404 device, and then a M-audio 2 port device. Can I record from both of these using Ardour and the Alsa driver? Or would I need to connect the devices to JACK, and then have Ardour connect to JACK as it's input?

I am debating purchasing Focusrite Scarlett 18i8 (4 ports), or alternatively a Roland UA-22 and a Focusrite Scarlett 2i2 (2 ports each)

510

r/RocketLeague•

I have run into a bug where the 2nd players paint color selection is not saved. When I exit out of the garage, the players colors revert back to the original color.

I have tried reinstalling rocket league, and I have removed the "saved data" folder in Document/My Games prior to reinstalling the program.

If you know of a solution for this I would love to hear it.

10