headbone

u/headbone


r/3Dprinting•

I bought a Kingroon to get started. I leveled the bed, printed some stuff. The quality wasn't perfect, I figured that's what you get for the price. Google said to adjust settings, they didn't help at all. The globbing and stringing got worse and worse until I was supervising and wiping excess off the side of the head every twenty minutes to prevent another glob.

I finally realized that the hot excess PLA goo was forming on the side of the head, so I realized that it must be leaking. I removed the cover, and while it was hot I tightened the nozzle with two wrenches. It was finger loose before, I can show you the blister on my thumb from where I grabbed it because my dumb ass forgot it

24


r/longrange•

As you increase distance over 300 yards little things become more important. I've seen demonstrations where at 1000 yards it matters if you're shooting east or west. At over 600 yards there is a slight but consistent difference if shooting with a bipod versus without. Fixed versus spring mounted bipods affect the point of impact differently too. To a beginner it's a surprisingly fussy science. High speed photography of a barrel flexing during firing is fascinating.

I see several people post to this subreddit showing their long range rifle with a cartridge holder slid onto the stock. Wouldn't a varying number of rifle cartridges on the stock affect the "harmonic reverberation" of the r

19

r/guns•

A lifelong dream finally realized. Damn it's got some kick! My first grouping is measured in feet rather than inches.

I chose this Ruger P345 primarily because of price, and also because I'm partial to a gun with a hammer, a safety, and a double action trigger. I am extremely satisfied.

Ruger P345 Update: My friend's 9mm has similar kick. I'm getting used to it. Thanks for all the advice.

1517

You've reached the end of this feed.