I have an LR Evo.
My oldest one is now throwing continuous bar faults.
This started a few weeks ago and after several attempts at cleaning it and a factory reset, it started working again.
This time, power cycling and factory resetting is not working. It comes back up and immediately goes to fault before the unit even gets past language selection.
If I take the tray out and hold down the tray sensor, I can keep pressing either bar (doesn't matter which one) and it'll cycle an inch at a time.
If it's not throwing bar fault, it will flash "obstruction" then go back to bar fault.
Not sure what else to do at this point.


