Door heat bug? (Oxygen Not Included)
Posted Nov 15, 2019, 9:20 PM UTC
Posted Nov 15, 2019, 9:20 PM UTC
Does it persist after reload?
Will opening/closing it change anything?
It persisted across reloads and open/close.
Post this bug on the forums! I’ve had it happen to my oil boiler too (sometimes the heat just won’t transfer past the door).
I've been getting some weird states with doors after loads, they show as open but are actually closed for heat calc/gas transfer, maybe this is related but in the opposite? cycling them manually fixes it
I posted it as you suggest. :)
yeah i've noticed this. I posted a comment on youtube but i'll do it here too:
try putting the door one more to the left, place a single diamond shift plate between the window tile and the door, and see if it transfers fine at that point.
Doors are weird and for some reason one side of them fail to transfer heat correctly (even when turned horizontally) and using a shift plate apparently allows them to transfer correctly.
I know it SHOULDNT be like this, but this is another workaround if you dont wanna break/replace the diamond tile every time.
TSP below/above the door would be in contact with dia and door. Maybe it fixes it (destroy TSP later, everything else is still in place).
Might be related to the clamping of total heat capacity with large temperature differences. See my bug report here.
I noticed this was possible in certain situations as well. I think if you transfer the heat from the ends of the door you'll be ok; I believe that's what I did.
Weird
This just happened to me while I was trying to make some sort of superhot free energy steam engine. My doors can't get hotter than 800 degrees for some reason.