Bug with using horizontal doors to control AETN... Looking for advice.

I have a typical setup where my AETN has horizontal doors under it to control the temp of the room. Temp gets low, triggers thermal sensor, doors open, AETN shuts off due to missing tile underneath. However, I noticed when my screen us up in my base (AETN is lower right corner of map), the AETN sometimes gets stuck on and continues cooling the room way beyond my thermo sensors. I assume this is a bug similar to some other off-screen weirdness I've seen posted here (heat transfer on rails when off-screen in the lower right, what a crazy bug).

Question: Anyone have any simple solutions for this? I can't figure out a way to make it work properly and I end up pumping -50 oxygen into my base before I notice it. I think I'm going to use a chill box between the AETN room and my Oxygen pipes so I can at least control the temp more precisely, but hoping someone has some insight on how to workaround this bug.

Posted Mar 24, 2020, 4:18 PM UTC

211
irishpete•

can you simply connect the thermo sensor automation wire to a gas shutoff valve and turn the AETN off by depriving it of hydrogen?

3
VortexJDOP•

Generally yes, but the control is not precise at all. The AETN uses a very small amount of Hydrogen so even with a shutoff it continues to run for a few minutes and still gets really cold. This would keep it from running away and getting to -150 before I realize it, but I'm not a big fan of this method.

2
psirrow•

It's a little more complicated to shutoff smaller packets, but you can do it by making a loop with a shutoff and a valve, bridging on before the valve input and taking output past the shutoff input. I use a similar thing for my sour gas boiler here. I don't remember where I got the idea, I think it was from a crypticfox video.

2
VortexJDOP•

Ugh a loop. Why did that not cross my mind. Thanks!

2
irishpete•

you should be able to record the 'drift' in temp change after shutoff, and adjust the thermo sensor to account for the extra hydrogen in the line

1
VortexJDOP•

That would keep it from going too cold, but the range in temps would still be pretty severe. I guess from a practicality standpoint, the amount of temp change in my base from my oxygen supply is super small, so I'm sure I'm being overly picky here.

1
DonaIdTrurnp•

Run the AETN to its limit, and then control how much you cool the things that need cooling.

1
shtiglitz•

I'm not sure if it fixed the problem because I didn't check on it very carefully and started a new playthrough shortly after. But when I had this happen I added a filter gate to it. It seemed to fix it short term. I think the problem was occuring when the sensor would switch back and forth between green and red too quickly, the state change of the door would confuse the AETN and it would stay on while the door was open.

1
VortexJDOP•

Interesting. The doors don't generally flicker too much, but this is easy to implement to see if it helps keep it from happening. Thanks for the suggestion!

2
shtiglitz•

Yeah the door itself doesn't do the flickering. It's the automation signal when the temperature is in a spot right at the threshold. I think that the automation signal that tells the door to open and close ends up confusing the game because the animation for the door itself doesn't get to complete.

1
SandGrainOne•

When I use n AETN for cooling I usually reverse the problem. If things get too cold I add more heat instead of stopping the AETN. In most of my systems I use a door to connect the cooling chamber to the "outside". Doesn't matter what.

1